Hello, I have three 12 volt SOK 206AH batteries wired in parrallel as a house bank on my boat (12V: 618AH). The batteries are connected to a Victron MultiPlus Inverter / Charger via a Lynx Shunt and Lynx Distributor. I also have a Cerbo GX monitoring the system. I am receiving a "lynx shunt high voltage alarm" on the Cerbo. The MultiPlus also ocassionally cycles off and re-starts. Has anyone experienced this issue? Any suggestions? The following are my Multiplus settings: Freq: 60HZ Cur Limit: 30A Dynamic Current Limiter: SELECTED Accept wide range input frequency range: SELECTED AC low disconnect:  90V AC high disconnect: 140V AC low connect: 97V                AC high connect:135V Inverter output voltage: 120V Ground Relay: SELECTED Power Assist: SELECTED Assist boost current Factor: 2.0 DC input low restart: 12.10V   DC input low pre-alarm: 12.10V Enable charge: SELECTED Bat Type: Lithium Ion Phosphate (LiFePo4) batteries Charge curve: FIXED Absorption Voltage: 14.6v Float Voltage: 13.8v Charge Current (Per battery): 120 Repeated absorption time:  1 HR  Repeated absorption interval: 7.00 Days Absorption time: 1.0 HR