Hello, I have three 12 volt SOK 206AH batteries wired in parrallel as a house bank on my boat (12V: 618AH). The batteries are connected to a Victron MultiPlus Inverter / Charger via a Lynx Shunt and Lynx Distributor. I also have a Cerbo GX monitoring the system. I am receiving a "lynx shunt high voltage alarm" on the Cerbo. The MultiPlus also ocassionally cycles off and re-starts. Has anyone experienced this issue? Any suggestions?
The following are my Multiplus settings:
Freq: 60HZ
Cur Limit: 30A
Dynamic Current Limiter: SELECTED
Accept wide range input frequency range: SELECTED
AC low disconnect: Â 90V
AC high disconnect: 140V
AC low connect: 97VÂ Â Â Â Â Â Â Â Â Â Â Â Â Â Â
AC high connect:135V
Inverter output voltage: 120V
Ground Relay: SELECTED
Power Assist: SELECTED
Assist boost current Factor: 2.0
DC input low restart: 12.10VÂ Â
DC input low pre-alarm:Â 12.10V
Enable charge: SELECTED
Bat Type: Lithium Ion Phosphate (LiFePo4) batteries
Charge curve: FIXED
Absorption Voltage: 14.6v
Float Voltage: 13.8v
Charge Current (Per battery): 120
Repeated absorption time: Â 1 HRÂ
Repeated absorption interval: 7.00 Days
Absorption time: 1.0Â HR